1 8 tongue and groove router bit8/5/2023 ![]() Once you’ve completed the first pass, clear out any debris from the groove, then flip the workpiece end-for-end and make a second pass (see Photo 1). Step 2: Push the stock through the bit using moderate feed speed. Clamp a featherboard to the table to press the wood firmly against the fence. Adjust and lock the fence so the bit is centered between its reference marks with the workpiece held in place. Install the straight bit in your router table, and raise it about 1/4-in. Hair-splitting accuracy isn’t crucial here - just get them close. Mark your workpiece with a couple short reference lines for centering the bit on the thickness of the wood. ![]() straight bit or spiral upcut bit makes an ideal groove-cutter into the edge of a workpiece. Step 1: Generally speaking, it’s easier to cut the groove of a T&G joint first, then mill the tongue to fit the groove. You can do it all at the router table easily with three different cutter approaches. Cutting the narrow centered groove and the corresponding tongue to fit into it doesn’t take a dado blade and table saw. There are DIY applications for this joint too, such as V-groove wainscot or wood flooring. ![]() Tongue-and-groove (T&G) joints form sturdy, interlocking connections with lots of glue surface area for all sorts of woodworking applications: cabinet door joints, self-aligning shelf edging, web or face frames and even carcass assembly. There’s no need for a dado blade if you have a router table and a few common bits. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |